Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Headlight Cleaner Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the conditions of the headlight cleaner switch.

WIRING DIAGRAM


E119092E01


INSPECTION PROCEDURE

1.CHECK HEADLIGHT OPERATION
  1. Check the headlight is operate normally.

    OK:
    The headlight operates normally.



NG
GO TO LIGHTING SYSTEM
OK


2.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY


    E125000E01
  1. Remove the headlight cleaner switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 8
    ON
    Below 25 Ω
    OFF
    10 kΩ or higher



NG
REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (CLEANER SWITCH - INSTRUMENT PANEL J/B, CLEANER RELAY)

E119093E02

  1. Disconnect the E4 headlight cleaner switch assembly connector.

  1. Disconnect the A39 headlight cleaner control relay connector.

  1. Disconnect the IH instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-8 - A39-2 (H)
    Always
    Below 1 Ω
    E4-8 - Body ground
    Always
    10 kΩ or higher
    E4-5 - IH-13
    Always
    Below 1 Ω
    E4-5 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK WIRE HARNESS (CLEANER RELAY - INSTRUMENT PANEL J/B)

E119094E01

  1. Disconnect the ID instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A39-1 (HDLO) - ID-3
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK INSTRUMENT PANEL J/B


    E119095E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IH-13 - Body ground
    Ignition switch ON and headlight dimmer switch OFF
    Below 1 V
    IH-13 - Body ground
    Ignition switch ON and headlight dimmer switch ON
    10 to 14 V



NG
REPLACE INSTRUMENT PANEL J/B
OK

REPLACE PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE