Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Rain Sensor Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the rain sensor.
The auto wiper system operates when the windshield wiper switch assembly is in the AUTO position.

WIRING DIAGRAM


B129039E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (WIPER RELAY - RAIN SENSOR)


    E125076E02
  1. Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

  1. Disconnect the Q4 rain sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-8 (SIG) - Q4-1 (SIG)
    Always
    Below 1 Ω
    E26-14 (PA1) - Q4-2 (AUTO)
    Always
    Below 1 Ω
    E26-25 (E) - Q4-4 (ES)
    Always
    Below 1 Ω
    Q4-1 (SIG) - Body ground
    Always
    10 kΩ or higher
    Q4-2 (AUTO) - Body ground
    Always
    10 kΩ or higher
    Q4-4 (ES) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE