Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Washer Motor Circuit

for Preparation Click here


DESCRIPTION

The windshield wiper relay assembly (auto wiper relay) controls the front washer motor.

WIRING DIAGRAM


E124991E05


INSPECTION PROCEDURE

1.INSPECT FUSE (WASH)
  1. Remove the WASH fuse from the instrument panel J/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (WASHER SWITCH)


  1. Remove the windshield wiper switch assembly.


    E119090E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Except Hong Kong, India and LHD:
    Tester Connection
    Switch Connection
    Specified Condition
    E19-2 (EW) - E19-3 (WF)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher
    Hong Kong, India:
    Tester Connection
    Switch Condition
    Specified Condition
    E19-1 (WF) - E19-2 (EW)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher



NG
REPLACE WINDSHIELD WIPER SWITCH ASSEMBLY
OK


3.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    E114464E01
  1. Remove the washer jar.

  1. Apply battery voltage to the windshield washer motor connector and check the operation of the windshield washer motor assembly.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal A37-1
    Battery negative (-) → Terminal A37-2
    Washer fluid flows from washer jar

    HINT:
    The check should be performed with the windshield washer motor and pump installed to the washer jar.



NG
REPLACE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR (BATTERY - WASHER MOTOR)
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    A37-2 - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (WASHER MOTOR - WIPER RELAY, WASHER SWITCH)


    E135009E01
  1. Disconnect the E19 windshield washer switch connector.

  1. Disconnect the A37 windshield washer motor connector.

  1. Disconnect the E26 auto wiper relay connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A37-1 - E26-4 (W)
    Always
    Below 1 Ω
    A37-1 - E19-3 (WF) (*1)
    Always
    Below 1 Ω
    A37-1 - E19-1 (WF) (*2)
    Always
    Below 1 Ω
    E19-2 (EW) - Body ground
    Always
    Below 1 Ω

    *1: Except Hong Kong, India and LHD
    *2: Hong Kong, India



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE