CAN COMMUNICATION SYSTEM (for LHD) > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Center Airbag Sensor Communication Stop Mode |
|
|

| 1.CHECK OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the center airbag sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| E30-13 (CANH) - E30-22 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (IG2, E1, E2) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| E30-25 (E1) - Body ground | Always | Below 1 Ω |
| E30-26 (E2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
| E30-21 (IG2) - Body ground | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | ||
| ||