Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    C133308
  1. Insert the stop light switch until the body hits the cushion.

    NOTICE:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.



    C131701E02
  1. Make a quarter turn clockwise to install the stop light switch.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.



    C133309E01
  1. Connect the stop light switch connector to the stop light switch.

  1. Check the protrusion of the rod (Click here).



2. INSTALL COMBINATION METER ASSEMBLY


    E128008
  1. Connect the 2 connectors as shown in the illustration.

  1. Secure the wire harness to the combination meter assembly.



    E128010
  1. Install the combination meter assembly as shown in the illustration.



    E128006
  1. Install the 4 screws.



3. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1


    E128011E01
  1. Engage the guide and the 4 claws.

  1. Install the instrument cluster finish panel with the 2 clips.



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System)


    B144612
  1. Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.



5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System)
  1. Connect the connector.



    B226061
  1. Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.



6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.



    B133986
  1. Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.



7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Install the air hose and connect the connector.

  1. Engage the 2 claws and the DLC3.

  1. Engage the claw and the 4 clips.

  1. Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.



8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the cowl side trim clip.



9. INSTALL FRONT DOOR SCUFF PLATE LH


    B132067
  1. Engage the 7 claws and 3 clips, then install the front door scuff plate LH.