Home › BODY ELECTRICAL › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE STEERING COLUMN COVER


    B137294E01
  1. Remove the 2 screws <D>.

  1. Disengage the 2 claws and remove the lower steering column cover.

  1. Disengage the claw and remove the upper steering column cover.



5. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY


    B133986
  1. Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the instrument panel sub-assembly.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System)


    B144612
  1. Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System)


    B226061
  1. Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.

  1. Disconnect the connector.



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1


    E128011E01
  1. Remove the 2 clips.

  1. Disengage the guide and 4 claws, and then remove the instrument cluster finish panel.



9. REMOVE COMBINATION METER ASSEMBLY
  1. Using the tilt and telescopic functions, fully lower and extend the steering wheel.



    E128006
  1. Remove the 4 screws.



    E128007
  1. Disconnect the 2 connectors.

  1. Disengage the wire harness from the combination meter assembly.



    E128009
  1. Remove the combination meter assembly as shown in the illustration.



10. REMOVE TURN SIGNAL FLASHER ASSEMBLY


    E128235E01
  1. Disconnect the connector.

  1. Remove the clamp and the turn signal flasher assembly.