Home › BODY ELECTRICAL › LIGHTING › GLOVE BOX LIGHT

GLOVE BOX LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL GLOVE BOX LIGHT ASSEMBLY


    E128205
  1. Engage the 2 claws and install the glove box light assembly.

  1. Connect the connector.



2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B133992E01
  1. Engage the 3 claws and 3 clips.

  1. Install the 4 screws <B>.

  1. Install the lower instrument panel sub-assembly with the bolt <A>.



3. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY


    B133989E01
  1. Engage the 4 claws and 2 guides and install the instrument panel No. 2 under cover.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures for the RH side and the LH side.