Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY


    B133998E01
  1. Apply protective tape to the areas shown in the illustration.



    B144610
  1. Using a moulding remover, disengage the 3 clips.



    B144611
  1. Using a moulding remover, disengage the 4 clips.

  1. Disconnect the connector and remove the instrument panel No. 2 register assembly.



2. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E128236
  1. Disengage the 4 claws and remove the hazard warning signal switch assembly.