HAZARD WARNING SWITCH > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY |
![]() |
Apply protective tape to the areas shown in the illustration.
![]() |
Using a moulding remover, disengage the 3 clips.
![]() |
Using a moulding remover, disengage the 4 clips.
Disconnect the connector and remove the instrument panel No. 2 register assembly.
| 2. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
![]() |
Disengage the 4 claws and remove the hazard warning signal switch assembly.