Home › ENGINE ยท 2AZ-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE TAIL PIPE ASSEMBLY


  1. Remove the 2 nuts and tail pipe assembly.


    A135689E01

  1. Remove the gasket from the center exhaust pipe.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


  1. Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.


    A135690E01

  1. Remove the gasket from the front exhaust pipe.



3. REMOVE HEATED OXYGEN SENSOR


    A135678E01
  1. Disconnect the heated oxygen sensor connector.



    A135679E01
  1. Using SST, remove the heated oxygen sensor from the exhaust pipe assembly front No. 3.

    SST
    09224-00010  

    NOTICE:
    Do not damage the heated oxygen sensor.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY


  1. Remove the 2 nuts.


    A135691

  1. Remove the 2 nuts, front exhaust pipe No. 1 support bracket and front exhaust pipe assembly.

  1. Remove the gasket from the exhaust manifold.



5. REMOVE REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET


    A132948E01
  1. Remove the 2 bolts and rear support bracket.