Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT RELAY

FOG LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT FOG LIGHT RELAY


    B060778E86
  1. Remove the front fog light relay from the instrument panel J/B assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the front fog light relay.



2. INSPECT REAR FOG LIGHT RELAY


    B060778E86
  1. Remove the rear fog light relay from the engine room No. 2 J/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the rear fog light relay.