Home › BODY ELECTRICAL › LIGHTING › TAILLIGHT RELAY

TAILLIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TAILLIGHT RELAY


    A087121E11
  1. Remove the taillight relay from the instrument panel J/B assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
    3 - 4
    Below 1 Ω
    10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the taillight relay.