WIPER AND WASHER SYSTEM > Power Source Circuit |

| 1.INSPECT FUSE (WIP) |
Remove the WIP fuse from the instrument panel J/B.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.INSPECT IG1 RELAY |
![]() |
Remove the IG1 relay from the instrument panel J/B.
Measure the resistance of the relay.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Always | 10 kΩ or higher |
| When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (WIPER RELAY - BATTERY, BODY GROUND) |
![]() |
Disconnect the E26 auto wiper relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E26-12 (IG) - Body ground | Ignition switch ON | 10 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E26-26 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||