Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (for LHD)

CAN COMMUNICATION SYSTEM (for LHD) > Open in One Side of CAN Branch Line

for Preparation Click here


DESCRIPTION

If 2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen, one side of the CAN branch wire may be open. (One side of the CAN-H [branch wire] / CAN-L [branch wire] of the ECU and/or sensor is open.)

Symptom
Trouble Area
2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen.
  1. One side of the CAN branch wire is open
  2. Steering angle sensor
  3. Skid control ECU
  4. ECM
  5. Yaw rate sensor
  6. Main body ECU
  7. A/C amplifier
  8. Center airbag sensor assembly
  9. Combination meter
  10. Navigation receiver assembly

WIRING DIAGRAM


C209583E01


C209584E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches or any triggers related ECU and sensor communication on the CAN, which would cause resistance reading variations.

1.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE
  1. Confirm the systems (ECUs and sensors), which use CAN communication, equipped on the vehicle. (Click here)

  1. Using the intelligent tester, select and perform "Communication Bus Check". (Click here) [*1]

  1. Disconnect the connectors from the ECUs or sensors that are not displayed on the screen. [*2]

  1. Check that only the ECUs and sensors from which the connectors were disconnected in the previous step are not displayed on the "Communication Bus Check" screen. [*3]

    HINT:
    If any ECUs or sensors, other than those from which the connectors were disconnected in the previous step, are not displayed on the "Communication Bus Check" screen, reconnect the disconnected connectors and repeat the procedures [*1], [*2], and [*3].

  1. Perform the communication stop mode check for the ECUs and sensors which correspond to the disconnected connectors. (Click here)


NEXT

GO TO CORRESPONDING COMMUNICATION STOP MODE