Home › BODY ELECTRICAL › LIGHTING › REAR ROOM LIGHT ASSEMBLY

REAR ROOM LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof)


    E116068
  1. Apply battery voltage to the No. 1 room light assembly connector.

  1. Check that the interior light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    DOOR
    Interior light comes on
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 3
    ON
    Interior light comes on

    If the result is not as specified, replace the bulb or room light assembly.



2. INSPECT SPOT LIGHT ASSEMBLY (w/ Sliding Roof)


    E121513E01
  1. Apply battery voltage to the spot light assembly connector.

  1. Check that the rear personal light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → Terminal Q10-2
    Battery negative (-) → Terminal Q10-4
    Pushed (ON)
    Rear RH personal light comes on
    Battery positive (+) → Terminal Q10-2
    Battery negative (-) → Terminal Q10-3
    Always
    Rear RH personal light comes on
    Battery positive (+) → Terminal Q11-2
    Battery negative (-) → Terminal Q11-4
    Pushed (ON)
    Rear LH personal light comes on
    Battery positive (+) → Terminal Q11-2
    Battery negative (-) → Terminal Q11-5
    Always
    Rear LH personal light comes on

    If the result is not as specified, replace the bulb or spot light assembly.