Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT PRESSURE SENSOR
  1. Install the manifold gauge set .



    E107326E08
  1. Connect the three 1.5 V dry cell batterie's positive (+) lead to terminal 3 and the negative (-) lead to terminal 1. Then connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1. Measure the voltage.

    OK:
    The voltage changes according to refrigerant pressure, as shown in the graph.

    If the voltage is not as specified, replace the pressure sensor.