STEERING PAD SWITCH > INSPECTION |
| 1. INSPECT STEERING PAD SWITCH |
Disconnect the steering pad switch assembly connector.

Measure the resistance according to the values in the table below.
| Tester connection | Condition | Specified condition |
| AU1 - EAU | No switch is pushed | Approx. 100 kΩ |
| AU1 - EAU | SEEK+ switch: push | 0 to 2.5 Ω |
| AU1 - EAU | SEEK- switch: push | Approx. 0.3 kΩ |
| AU1 - EAU | VOL+ switch: push | Approx. 1 kΩ |
| AU1 - EAU | VOL- switch: push | Approx. 3.1 kΩ |
| AU2 - EAU | No switch is pushed | Approx. 100 kΩ |
| AU2 - EAU | MODE switch: push | 0 to 2.5 Ω |