STEERING PAD SWITCH > INSPECTION |
| 1. INSPECT STEERING PAD SWITCH |
Disconnect the steering pad switch assembly connector.

Measure the resistance according to the values in the table below.
| Tester Connection | Condition | Specified Condition |
| AU1 - EAU | No switch is pushed | 95 to 105 kΩ |
| AU1 - EAU | Seek+ switch: pushed | Below 2.5 Ω |
| AU1 - EAU | Seek- switch: pushed | 313.5 to 346.5 Ω |
| AU1 - EAU | Volume+ switch: pushed | 959.5 to 1060.5 Ω |
| AU1 - EAU | Volume- switch: pushed | 3049.5 to 3370.5 Ω |
| AU2 - EAU | No switch is pushed | 95 to 105 kΩ |
| AU2 - EAU | MODE switch: pushed | Below 2.5 Ω |
| AU2 - EAU | Voice switch: pushed*1 | 3049.5 to 3370.5 Ω |
| AU2 - EAU | On hook switch: pushed*1 | 313.5 to 346.5 Ω |
| AU2 - EAU | Off hook switch: pushed*1 | 959.5 to 1060.5 Ω |