Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the navigation receiver assembly through this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.

WIRING DIAGRAM


E185297E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO JACK ADAPTER)


    E168561E25
  1. Disconnect the navigation receiver assembly connector.



    E163029E08
  1. Disconnect the stereo jack adapter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F24-19 (AUXI) - F30-4 (AUXO)
    Always
    Below 1 Ω
    F24-18 (AGND) - F30-5 (AGND)
    Always
    Below 1 Ω
    F24-15 (ARI) - F30-2 (ARO)
    Always
    Below 1 Ω
    F24-17 (ALI) - F30-1 (ALO)
    Always
    Below 1 Ω
    F24-16 (ASGN) - F30-3 (ASGN)
    Always
    Below 1 Ω
    F24-19 (AUXI) - Body ground
    Always
    10 kΩ or higher
    F24-18 (AGND) - Body ground
    Always
    10 kΩ or higher
    F24-15 (ARI) - Body ground
    Always
    10 kΩ or higher
    F24-17 (ALI) - Body ground
    Always
    10 kΩ or higher
    F24-16 (ASGN) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *2
    Front view of wire harness connector
    (to Stereo Jack Adapter)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)