DTC B2289 Key Collation Waiting Time Over |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2289 | Either condition below is met:
|
|


| 1.CHECK FOR DTCS |
Delete the DTCs (Click here).
Check for DTC B2289 and B2785.
| Display (DTC output) | Proceed to |
| "DTC B2289" only | A |
| "DTC B2785" only | B |
| No DTC | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (MAIN BODY ECU - CERTIFICATION ECU) |
Disconnect the E74 and IR ECU connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IR-9 (LIN1) - E74-10 (LIN) | Always | Below 1 Ω |
| IR-9 (LIN1) or E74-10 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine starts.
|
| ||||
| OK | ||
| ||