Home › ENGINE · 2GR-FE › STARTING › ENTRY AND START SYSTEM

DTC    B2289    Key Collation Waiting Time Over

for Preparation Click here


DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU and certification ECU or when there is a problem in the engine immobiliser system.

HINT:
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.


DTC No.
DTC Detection Condition
Trouble Area
B2289
Either condition below is met:
  1. Cable and CAN are abnormal between the main body ECU and the engine immobiliser system
  2. The engine immobiliser system is malfunctioning
  1. Main body ECU
  2. Engine immobiliser system
  3. Wire harness or connector
  4. Certification ECU

B137997E02


WIRING DIAGRAM


B137989E24


INSPECTION PROCEDURE

1.CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. Check for DTC B2289 and B2785.

    Result:
    Display (DTC output)
    Proceed to
    "DTC B2289" only
    A
    "DTC B2785" only
    B
    No DTC
    C

    HINT:
    1. If DTC B2785 is output, perform troubleshooting for DTC B2785 first (Click here).



B
GO TO DTC B2785

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.CHECK WIRE HARNESS (MAIN BODY ECU - CERTIFICATION ECU)


  1. Disconnect the E74 and IR ECU connectors.


    B184301E04

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    IR-9 (LIN1) - E74-10 (LIN)
    Always
    Below 1 Ω
    IR-9 (LIN1) or E74-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine starts.

    OK:
    Engine can start normally.

    HINT:
    If the engine does not start, refer to PROBLEM SYMPTOMS TABLE of the entry and start system (entry) (Room Oscillator does not Recognize Key) (Click here).



NG
GO TO ENTRY AND START SYSTEM (ENTRY)
OK

END (MAIN BODY ECU WAS DEFECTIVE)