Home › ENGINE ยท 2GR-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Click here.



2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A129631E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011   (09213-70020)
    09330-00021  



    A132243
  1. Remove the 8 bolts, front spacer, drive plate and rear spacer.



3. REMOVE ENGINE REAR OIL SEAL


    A132244E01
  1. Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft. Tape the screwdriver tip before use.