ENGINE FRONT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING CHAIN CASE OIL SEAL |
![]() |
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT PULLEY |
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
![]() |
Using SST, install the pulley bolt.
| 3. INSTALL V-RIBBED BELT |
![]() |
Install the V-ribbed belt.
Using SST, turn the belt tensioner counterclockwise and remove the bar.
![]() |
If it is difficult to install the V-ribbed belt, perform the following procedure:
Put the V-ribbed belt on every pulley except the tensioner pulley as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.
| 4. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Engage the 3 retainers to install the V-bank cover.
| 5. INSTALL FRONT FENDER APRON SEAL RH |
| 6. INSTALL FRONT WHEEL RH |