Home › ENGINE ยท 2GR-FE › ENGINE MECHANICAL › ENGINE FRONT OIL SEAL

ENGINE FRONT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER APRON SEAL RH


3. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



4. REMOVE V-RIBBED BELT


    A129622E01
  1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

    SST
    09249-63010  



    A095070
  1. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.



5. REMOVE CRANKSHAFT PULLEY


    A119083E01
  1. Using SST, loosen the crankshaft pulley bolt.

    SST
    09213-70011   (09213-70020)
    09330-00021  



    A119085E01
  1. Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



6. REMOVE TIMING CHAIN CASE OIL SEAL


    A132241E01
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.