MASS AIR FLOW METER > ON-VEHICLE INSPECTION |
| 1. CHECK MASS AIR FLOW METER |
Perform confirmation driving pattern.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Start the engine and warm it up with all accessory switches off (until the engine coolant temperature is 75°C (167°F) or more).
Drive the vehicle at 31 mph (50 km/h) or more for 3 minutes or more (*1).
Allow the engine to idle (accelerator pedal fully released) for 2 minutes or more (*2).
Perform steps (*1) and (*2) at least 3 times or more.

Read values using the intelligent tester (LONG FT#1).
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / LONG FT#1.
Read the values displayed on the tester.
Read values using the intelligent tester (MAF).
Turn off the engine (do not run the engine).
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / PRIMARY / PRIMARY / MAF.
Wait 30 seconds, and read the values on the intelligent tester.