BRAKE PEDAL > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY |
![]() |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
| 4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and the 2 clips.
Disconnect each connector and remove the instrument panel sub-assembly.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
| 6. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Remove the 2 clips.
Disengage the guide and 4 claws and then remove the instrument cluster finish panel.
| 7. REMOVE COMBINATION METER ASSEMBLY |
![]() |
Remove the 4 screws <E>.
Disconnect each connector and remove the combination meter assembly.
| 8. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY |
![]() |
Disconnect the connector.
Remove the bolt and the headlight leveling ECU assembly.
| 9. REMOVE ACCELERATOR PEDAL ROD (for RHD) |
![]() |
Disconnect the accelerator pedal position sensor connector.
Remove the 2 bolts and accelerator pedal rod.
| 10. REMOVE BRAKE BOOSTER ASSEMBLY |
| 11. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for LHD) |
![]() |
Disconnect the stop light switch connector and disengage the 2 clamps.
![]() |
Remove 2 bolts (A), bolt (B) and the No. 1 brake pedal support plate.
![]() |
Remove the bolt and the brake pedal support assembly.
| 12. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for RHD) |
![]() |
Disconnect the 2 connectors.
Remove the 2 bolts and accelerator pedal.
![]() |
Disconnect the stop light switch connector.
![]() |
Remove 2 bolts (A), bolt (B) and the No. 1 brake pedal support plate.
![]() |
Remove the bolt and the brake pedal support assembly and disengage the clamp.