STOP LIGHT SWITCH > INSTALLATION |
| 1. INSTALL STOP LIGHT SWITCH |
![]() |
Insert the stop light switch until the body hits the cushion.
![]() |
Make a quarter turn clockwise to install the stop light switch.
![]() |
Connect the stop light switch connector to the stop light switch.
Check the protrusion of the rod (Click here).
| 2. INSTALL COMBINATION METER |
![]() |
Connect each connector.
Install the combination meter assembly with the 4 screws <E>.
| 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Engage the guide and the 4 claws.
Install the instrument cluster finish panel with the 2 clips.
| 4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System) |
![]() |
Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.
| 5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System) |
Connect the connector.
![]() |
Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.
| 6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
Connect each connector.
![]() |
Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.
| 7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Install the air hose and connect the connector.
Engage the 2 claws and the DLC3.
Engage the claw and the 4 clips.
Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.
| 8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the cowl side trim clip.
| 9. INSTALL FRONT DOOR SCUFF PLATE LH |
![]() |
Engage the 7 claws and 3 clips, then install the front door scuff plate LH.