Home › BRAKE › BRAKE › STOP LIGHT SWITCH

STOP LIGHT SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY


    B133986
  1. Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the instrument panel sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL


    B144612
  1. Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.



6. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1


    B133985E01
  1. Remove the 2 clips.

  1. Disengage the guide and 4 claws and then remove the instrument cluster finish panel.



7. REMOVE COMBINATION METER


    B133987E01
  1. Remove the 4 screws <E>.

  1. Disconnect each connector and remove the combination meter assembly.



8. REMOVE STOP LIGHT SWITCH


    C133309E01
  1. Disconnect the stop light switch connector from the stop light switch.



    C133307
  1. Turn the stop light switch counterclockwise and remove the stop light switch.