STOP LIGHT SWITCH > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
| 4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and the 2 clips.
Disconnect each connector and remove the instrument panel sub-assembly.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System) |
![]() |
Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System) |
![]() |
Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
Disconnect the connector.
| 7. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Remove the 2 clips.
Disengage the guide and 4 claws and then remove the instrument cluster finish panel.
| 8. REMOVE COMBINATION METER |
![]() |
Remove the 4 screws <E>.
Disconnect each connector and remove the combination meter assembly.
| 9. REMOVE STOP LIGHT SWITCH |
![]() |
Disconnect the stop light switch connector from the stop light switch.
![]() |
Turn the stop light switch counterclockwise and remove the stop light switch.