Home › BRAKE › BRAKE CONTROL › SKID CONTROL BUZZER (w/ VSC)

SKID CONTROL BUZZER (w/ VSC) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY


    B133986
  1. Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the instrument panel sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System)


    B144612
  1. Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System)


    B226061
  1. Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.

  1. Disconnect the connector.



7. REMOVE SKID CONTROL BUZZER


    C133331E01
  1. Disconnect the skid control buzzer connector.

  1. Remove the clip and skid control buzzer.