Home › ENGINE · 2GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


    A094922
  1. Using an ohmmeter, measure the resistance between the terminals.

    Resistance:
    1,630 to 2,740 Ω at cold
    2,065 to 3,225 Ω at hot

    NOTICE:
    The terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the sensor.