Home
›
ENGINE · 2GR-FE
›
ENGINE CONTROL SYSTEM
›
ENGINE COOLANT TEMPERATURE SENSOR
ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
Measure the resistance between the terminals.
Standard resistance:
Condition
Specified Condition
Approx. 20°C (68°F)
2.32 to 2.59 kΩ
Approx. 80°C (176°F)
0.31 to 0.326 kΩ
If the result is not as specified, replace the sensor.
NOTICE:
If checking the ECT sensor in the water, keep the terminals dry. After checking, dry the sensor.