Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH


2. REMOVE ENGINE UNDER COVER RH


3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.


    A128117E02

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



4. REMOVE COOL AIR INTAKE DUCT SEAL


    A132967
  1. Remove the 7 clips and intake duct seal.



5. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 retainers on the front of the cover. Continue to raise the cover to disengage the retainer on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



6. REMOVE AIR CLEANER INLET ASSEMBLY


    A132969
  1. Remove the 2 bolts, clamp and air cleaner inlet.



7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135704
  1. Disconnect the 3 vacuum hoses.



    A135705E01
  1. Disconnect the mass air flow meter connector (*1).

  1. Disconnect the No. 2 ventilation hose (*2).

  1. Disconnect the hose band (*3).



    A135706
  1. Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.



8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A132971
  1. Disconnect the vacuum hose and hose clamp.

  1. Remove the 3 bolts and air cleaner case.



9. REMOVE NO. 1 AIR CLEANER INLET


    A132970
  1. Remove the bolt and No. 1 air cleaner inlet.



10. REMOVE THROTTLE BODY


    A135707
  1. Disconnect the throttle body connector and clamp.



    A135708
  1. Disconnect the 2 water by-pass hoses from the throttle body.



    A135709
  1. Remove the 4 bolts and throttle body.

  1. Remove the throttle body gasket from the intake air surge tank.