Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECTION THROTTLE BODY


    A129612
  1. Inspect the throttle control motor for operating sounds.

    1. Turn the ignition switch on (IG).

    2. When turning the accelerator pedal position sensor lever, check for running sounds of the motor. The motor should be running smoothly without friction sounds.
      If operation is not as specified, check the throttle control motor, wiring and ECM .



  1. Inspect the throttle position sensor.



      B139188E02
    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Check that the MIL is off.

    4. Check that, under the CURRENT DATA, THROTTLE POS (throttle valve opening percentage) is within the standard range below.

      Standard throttle valve opening percentage:
      60 % or more

      If operation is not as specified, check the throttle position sensor, wiring and ECM .