Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E128807
  1. Remove the nut and the front wiper arm and blade assembly LH.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E128808
  1. Remove the nut and the front wiper arm and blade assembly RH.



3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    E128809
  1. Disengage the claw and remove the front fender to cowl side seal LH.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH


    E128810
  1. Disengage the claw and remove the front fender to cowl side seal RH.



5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E128811
  1. Remove the 2 clips.

  1. Disengage the 4 claws and remove the cowl top ventilator louver sub-assembly.



6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E128812
  1. Disconnect the connector.



    E128813
  1. Remove the 4 bolts and the windshield wiper motor and link assembly.



7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E128814E01
  1. Using a screwdriver, separate the No. 2 windshield wiper link rod from the crank arm pivot of the front wiper motor assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    E128815
  1. Move the crank arm in the direction indicated by the arrow.



    E128816
  1. Remove the 3 bolts and the windshield wiper motor assembly from the windshield wiper link assembly.