Home › BODY ELECTRICAL › OTHER SYSTEM › POWER OUTLET SOCKET

POWER OUTLET SOCKET > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)


    B148446
  1. Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B144609
  1. Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.



3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B144599
  1. Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.



4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B144605
  1. Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.



5. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle)


    B148447
  1. Disengage the 6 claws and the 3 clips, and then remove the floor shift position indicator housing sub-assembly.

  1. with Seat Heater System:

    1. Disconnect each connector.



6. REMOVE UPPER CONSOLE PANEL (for Manual Transaxle)


    B144607E01
  1. Open the lid of the upper console panel.

  1. Apply protective tape to the area shown in the illustration.



    B144602
  1. Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the upper console panel as shown in the illustration.



7. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle)


    B144603E01
  1. Disengage the 3 claws and the 5 clips.

  1. Disengage the clamp.

  1. Disconnect the connector and remove the upper console rear panel sub-assembly.



8. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle)


    B144604
  1. Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.



9. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY


    B141243E01
  1. Remove the 2 screws <F>.

  1. Disengage the 4 claws.

  1. Disconnect each connector and remove the instrument cluster finish panel center sub-assembly.

    HINT:
    Set the shift lever in the D position.



10. REMOVE FRONT POWER OUTLET SOCKET ASSEMBLY


    E129967
  1. Disengage the claw and remove the front power outlet socket assembly.



11. REMOVE REAR POWER OUTLET SOCKET ASSEMBLY (for Automatic Transaxle)


    E129969
  1. Disengage the claw and remove the rear power outlet socket assembly.