POWER DOOR LOCK CONTROL SYSTEM > Luggage Compartment Door Courtesy Switch Circuit |

| 1.READ VALUE USING DATA LIST (DOOR COURTESY SWITCH) |
Check the DATA LIST for proper functioning of the door courtesy switch.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Luggage Courtesy SW | Luggage compartment door courtesy light switch signal / ON or OFF | ON: Luggage compartment door is OPEN OFF: Luggage compartment door is CLOSED | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (DOOR COURTESY SWITCH) |
![]() |
Remove the luggage compartment door lock.
Measure the resistance between the specified terminals of the switch.
| Tester Connection | Condition | Specified Condition |
| 2 - 3 | UNLOCK | Below 1 Ω |
| 2 - 3 | LOCK | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (LUGGAGE COMPARTMENT DOOR LOCK - MAIN BODY ECU) |
![]() |
Disconnect the ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| S5-3 - E6-25 (LGCY) | Always | Below 1 Ω |
| S5-3 - Body ground | Always | 10 kΩ or higher |
| S5-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||