Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Luggage Compartment Door Lock Circuit

for Preparation Click here


DESCRIPTION

The luggage compartment door lock motor is built into the luggage compartment door lock assembly.
The main body ECU receives a luggage compartment door unlock signal from the luggage compartment door lock cylinder and operates the door lock motor.

WIRING DIAGRAM


B137939E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST (LUGGAGE COMPARTMENT DOOR)
  1. Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the door lock operates.

    Main Body 
    Item
    Test Details
    Diagnostic Note
    Trunk and Back-Door Open
    Operate luggage compartment door lock motor LOCK/UNLOCK
    -

    OK:
    Door lock is locked/unlocked.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (DOOR LOCK MOTOR)


    B193381E06
  1. Remove the luggage compartment door lock assembly.

  1. Apply battery voltage and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Unlock



NG
REPLACE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
OK


3.CHECK WIRE HARNESS (LUGGAGE COMPARTMENT DOOR LOCK - MAIN BODY ECU)


    B137938E01
  1. Disconnect the ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E7-1 (TR+) - S5-1
    Always
    Below 1 Ω
    S5-1 - Body ground
    Always
    10 kΩ or higher
    S5-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE