Home › BODY ELECTRICAL › HORN › LOW PITCHED HORN

LOW PITCHED HORN > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)


    B138886
  1. Remove the 7 clips and cool air intake duct seal.



2. REMOVE FRONT BUMPER ASSEMBLY (w/o Headlight Cleaner System)


    B140159E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B137735
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B137736
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect 2 fog light connectors.

  1. w/ TOYOTA Parking Assist-sensor System:

    1. Disengage the clamp and disconnect the clearance sonar connector.

  1. Remove the front bumper assembly.



3. REMOVE FRONT BUMPER ASSEMBLY (w/ Headlight Cleaner System)


    B137734E01
  1. Put protective tape around the front bumper assembly.



    B138884E01
  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B140161
  1. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.



    B140160
  1. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect 2 fog light connectors.

  1. w/ TOYOTA Parking Assist-sensor System:

    1. Disengage the clamp and disconnect the clearance sonar connector.



    B137737
  1. Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.



4. REMOVE LOW PITCHED HORN ASSEMBLY


    E127997
  1. Disconnect the connector.

  1. Remove the bolt and the low pitched horn assembly.