Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > INSTALLATION

for Preparation Click here



1. INSTALL COMBINATION METER ASSEMBLY


    E128008
  1. Connect the 2 connectors as shown in the illustration.

  1. Secure the wire harness to the combination meter assembly.



    E128010
  1. Install the combination meter assembly as shown in the illustration.



    E128006
  1. Install the 4 screws.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1


    E128011E01
  1. Engage the guide and the 4 claws.

  1. Install the instrument cluster finish panel with the 2 clips.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Entry and Start System)


    B144612
  1. Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Entry and Start System)
  1. Connect the connector.



    B226061
  1. Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.



5. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector.



    B133986
  1. Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.



6. INSTALL STEERING COLUMN COVER


    E128005
  1. Engage the claw and install the upper steering column cover.



    E128004
  1. Engage the 2 claws.

  1. Install the lower steering column cover with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH
  1. Install the air hose and connect the connector.



    B147263
  1. Engage the claw and the 4 clips.

  1. Connect the hood lock control cable assembly.

  1. Engage the 2 claws and connect the connector.

  1. Install the lower instrument panel finish panel LH with the screw and bolt.



8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the cowl side trim clip.



9. INSTALL FRONT DOOR SCUFF PLATE LH


    B132067
  1. Engage the 7 claws and 3 clips, then install the front door scuff plate LH.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL