RADIO ANTENNA CORD > INSTALLATION |
| 1. INSTALL ANTENNA CORD SUB-ASSEMBLY |
Apply new double-sided tape.

Remove the double-sided tape from the roof headlining assembly.
Peel off the appropriate amount of new double-sided tape. Be careful not to touch the adhesive surface.
Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.
Peel off the backing sheet from the double-sided tape.
Install the antenna cord to the roof headlining assembly from the front of the vehicle.

Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for LHD) |
Engage the 6 clamps and clip and install the No. 2 antenna cord sub-assembly.

| 4. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for RHD) |
Engage the 6 clamps and clip and install the No. 2 antenna cord sub-assembly.

| 5. INSTALL NO. 2 HEATER TO REGISTER DUCT |
![]() |
Install the No. 2 heater to register duct with the 2 screws <F>.
| 6. INSTALL NO. 3 HEATER TO REGISTER DUCT |
![]() |
Install the No. 3 heater to register duct with the 3 screws <F>.
| 7. INSTALL NO. 1 HEATER TO REGISTER DUCT |
![]() |
Install the No. 1 heater to register duct with the 3 screws <F>.
| 8. INSTALL DEFROSTER NOZZLE ASSEMBLY |
![]() |
Install the defroster nozzle assembly with the 3 screws <F>.
| 9. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT |
![]() |
Install the side No. 2 defroster nozzle duct with the screw <F>.
| 10. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT |
![]() |
Install the side No. 1 defroster nozzle duct with the screw <F>.
| 11. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY |