Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › SHIFT LEVER

SHIFT LEVER > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION CONTROL SWITCH


    C110341E15
  1. Measure resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

    Standard resistance:
    Shift Position
    Tester Connection
    Specified Condition
    S, "+" and "-"
    3 - 7
    Below 1 Ω
    Except S, "+" and "-"
    3 - 7
    10 kΩ or higher
    Press continuously "+" (Up shift)
    2 - 5
    Below 1 Ω
    S
    2 - 5
    10 kΩ or higher
    Press continuously "-" (Down shift)
    1 - 5
    Below 1 Ω
    S
    1 - 5
    10 kΩ or higher

    If the resistance value is not as specified, replace the shift lock control ECU.