SHIFT LEVER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL |
![]() |
Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.
| 6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 7. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.
| 8. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.
| 9. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY |
![]() |
Disengage the 6 claws and the 3 clips, and then remove the floor shift position indicator housing sub-assembly.
with Seat Heater System:
Disconnect each connector.
| 10. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and the 5 clips.
Disconnect the connector and remove the upper console rear panel sub-assembly.
| 11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 screws <F>.
Disengage the 4 claws.
Disconnect each connector and remove the upper console panel sub-assembly.
| 12. REMOVE CONSOLE BOX POCKET |
Remove the console box pocket.
| 13. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
| 14. REMOVE CONSOLE BOX ASSEMBLY |
![]() |
Remove the 2 screws <F>.
![]() |
Remove the 2 bolts <G> and the console box assembly.
| 15. REMOVE NO. 2 CONSOLE BOX INSERT FRONT |
![]() |
Remove the 3 screws <F>.
Disengage the clip and remove the No. 2 console box insert front.
| 16. REMOVE FLOOR CARPET BRACKET LH |
![]() |
Release the clamp.
Turn back the floor carpet.
![]() |
Remove the 3 clips.
Remove the floor carpet bracket LH.
| 17. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
Disconnect the end of the transmission control cable assembly from the shift lock control unit.
![]() |
Disconnect the transmission control cable assembly from the shift lock control unit.
| 18. REMOVE SHIFT LOCK CONTROL UNIT |
![]() |
Disconnect the shift lock control ECU connector and transmission control switch wire connector.
![]() |
Remove the 4 bolts and shift lever.