Home › TRANSMISSION · U660E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

When the ignition switch is turned on, voltage from the ECM's MREL terminal is applied to the EFI relay. This causes the contacts of the EFI relay to close, which supplies power to terminal +B of the TCM.

WIRING DIAGRAM


C133264E01


INSPECTION PROCEDURE

1.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL)


    C133210E06
  1. Disconnect the TCM connector.

  1. Turn the ignition switch on.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    +B (C56-18) - E1 (C56-8)
    9 to 14 V



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


2.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)


    C133210E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E1 (C56-8) - Body ground
    Below 1 Ω

  1. Reconnect the TCM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BODY GROUND)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - EFI RELAY)