DTC P0715 Input / Turbine Speed Sensor Circuit Malfunction |
DTC P0717 Input Speed Sensor Circuit No Signal |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0715 | When the speed sensor input voltage is either more than 1.9 V or less than 0.1 V for 4.5 seconds or more. |
|
| P0717 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more (1-trip detection logic): (a) Vehicle speed: 31 mph (50 km/h) or more. (b) Park/neutral position switch (STAR and R) is OFF. (c) Speed sensor (NT): less than 300 rpm. |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn on the tester.
Enter the following items: "Powertrain / ECT / Data List".
According to the display on the tester, read "Data List".
| Item | Measurement Item/ Range (display) | Normal Condition |
| SPD (NT) | Input Turbine Speed / display: 50 r/min |
|
| 1.INSPECT SPEED SENSOR (SENSOR INSTALLATION) |
![]() |
Make sure that the connector is properly connected, and check the speed sensor installation.
|
| ||||
| OK | |
| 2.CHECK TRANSMISSION WIRE |
![]() |
Remove the TCM.
Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
| NTO - NTO | Below 1 Ω |
| NTB - NTB | Below 1 Ω |
| NTO - NTB | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE SPEED SENSOR |
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0715 AND/OR P0717 IS OUTPUT AGAIN) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester main switch ON.
Perform the monitor drive pattern (Click here).
When you use intelligent tester:
Select the item "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0715 or P0717" is output | A |
| No output | B |
|
| ||||
| A | ||
| ||