IGNITION KEY CYLINDER LIGHT > INSTALLATION |
| 1. INSTALL TRANSPONDER KEY AMPLIFIER |
Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.
![]() |
Push the transponder key amplifier to install it to the upper bracket.
| 2. INSTALL STEERING COLUMN COVER |
![]() |
Engage the claw and install the upper steering column cover.
![]() |
Engage the 2 claws.
Install the lower steering column cover with the 2 screws.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Install the air hose and connect the connector.
Engage the 2 claws and the DLC3.
Engage the claw and the 4 clips.
Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.
| 4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the cowl side trim clip.
| 5. INSTALL FRONT DOOR SCUFF PLATE LH |
![]() |
Engage the 7 claws and 3 clips, then install the front door scuff plate LH.