Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL TRANSPONDER KEY AMPLIFIER
  1. Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.



    C115570
  1. Push the transponder key amplifier to install it to the upper bracket.

    NOTICE:
    Do not push the amplifier with excessive force.



2. INSTALL STEERING COLUMN COVER


    E128005
  1. Engage the claw and install the upper steering column cover.



    E128004
  1. Engage the 2 claws.

  1. Install the lower steering column cover with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Install the air hose and connect the connector.

  1. Engage the 2 claws and the DLC3.

  1. Engage the claw and the 4 clips.

  1. Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the cowl side trim clip.



5. INSTALL FRONT DOOR SCUFF PLATE LH


    B132067
  1. Engage the 7 claws and 3 clips, then install the front door scuff plate LH.