IGNITION KEY CYLINDER LIGHT > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH |
![]() |
Remove the cowl side trim clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH |
![]() |
Remove the bolt <A> and the screw <B>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.
| 4. REMOVE STEERING COLUMN COVER |
![]() |
Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.
![]() |
Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.
![]() |
Disengage the 2 claws and remove the steering column cover lower.
![]() |
Disengage the claw and remove the steering column cover upper.
| 5. REMOVE TRANSPONDER KEY AMPLIFIER |
Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).
![]() |
Pull out the transponder key amplifier with the claw open.