Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B132067
  1. Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B132116E01
  1. Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH


    B147263E01
  1. Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower instrument panel finish panel LH.



4. REMOVE STEERING COLUMN COVER


    E128001
  1. Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.



    E128002
  1. Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.



    E128003
  1. Disengage the 2 claws and remove the steering column cover lower.



    E128005
  1. Disengage the claw and remove the steering column cover upper.



5. REMOVE TRANSPONDER KEY AMPLIFIER
  1. Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).



    C115569
  1. Pull out the transponder key amplifier with the claw open.

    NOTICE:
    Using excessive force may damage the case.