Home › BODY › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY

LUMBAR SUPPORT ADJUSTER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (for LHD)


    B065478E06
  1. Check operation of the lumbar support adjuster.

    1. Check if the lumber support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminals.

      OK:
      Measurement Condition
      Operation Direction
      Battery positive (+) → U5-2
      Battery negative (-) → U5-1
      Clockwise
      Battery positive (+) → U5-1
      Battery negative (-) → U5-2
      Counterclockwise

      If the result is not as specified, replace the lumbar support adjuster.



2. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY RH (for RHD)


    B065478E10
  1. Check operation of the lumbar support adjuster.

    1. Check if the lumber support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminals.

      OK:
      Measurement Condition
      Operation Direction
      Battery positive (+) → T5-1
      Battery negative (-) → T5-2
      Clockwise
      Battery positive (+) → T5-2
      Battery negative (-) → T5-1
      Counterclockwise

      If the result is not as specified, replace the lumbar support adjuster.